Preparing to Bring in Coax from the Pole

When you’re ready to hook up your home to the latest in entertainment or high-speed internet, knowing how to run coaxial cable from the utility pole to your abode is key. Here’s the lowdown on getting it done like a pro.

First things first, gather your toolkit. You’ll need:

• Coaxial cable
• Coaxial cable connectors
• Coaxial cable clips
• Cable stripping tool
• Drill with drill bits
• Screwdrivers
• Wrenches
• Ladder or scaffold

Before you climb up that ladder, give your cable provider a ring to ensure you’re clear to fiddle with their gear.

Bringing in Coaxial Cable from the Pole

Spot the cable entry point on your house, typically near the roofline. Get your ladder or scaffold in place and head on up.

Clear out any old cable or debris, then get your coaxial cable ready by attaching a connector with your stripping tool.

Guide the coaxial cable through the entry point, heading down to terra firma. Secure the cable to your home’s exterior with those clips.

Don’t forget a grounding block near the entry point to keep your gear safe from surges.

Lay the cable out to the pole, leaving some slack for the unpredictable whims of Mother Nature.

Drill a hole or set up a conduit at the pole’s base, then run the cable up and fasten it securely.

Give any connectors or fasteners a good wrench-tightening, then test your setup by connecting your equipment and looking for a signal.

Conclusion

Running coaxial cable from the pole to your house might seem daunting, but with the right tools and a bit of savvy, you can DIY with confidence. Just remember, safety first and always check with your cable provider before you start.